BOTZ PS42 - 100% leak-proof sealing solution for metal threaded joints
Medium-viscosity, high-strength well penetrating into fine threads resisting up to -50°C /+200°C. Solvent-free. Non-dripping. When fully cured, will seal up to the bursting pressure of the pipe.
Seals anaerobically. Keeps its strength and sealing properties against shocks & vibrations long after the application. Used on close-fitting metal pipe threads where all kinds of water, oil, grease, and many chemicals pass. Can also be used in assembling joint parts of pressure vessels, air compressors, hydraulic systems and tanks, and in areas where resistance against vibration is required.
Suitable for Type H thick metal thread joints according to TSE EN 751-1 Standard.
FEATURES:
Suitable for metal-metal and plastic-metal threaded connections
No dirt with its non-dripping formulation
Keeps its sealing properties against shocks & vibrations long after the application
Very high setting speed even at cold temperatues(<0°C)
Resists high temperatures with maintaining high strength.
APPLICATION AREAS:
Close-fitting metal pipe threads where all kinds of water, oil, grease, and many chemicals pass
Pressure vessels
Air compressors
Hydraulic systems and tanks
Areas where resistance against vibration is required
Suitable for Type H thick metal thread joints according to TSE EN 751-1 Standard.
APPLICATION:
1) Ensure parts are clean, dry and free from oil and grease.
2) Applied with a brush or directly from tube.
3) Apply the adhesive with a 360 turn to leading threads of the male and female fittings.
4) Use an absorbent tissue paper to wipe off excess jointing compound in the direction of the thread.
5) Assembly parts and hold on for 24 hours at 22-24°C to ensure full curing of jointing compound.
6) For disassembly, use hand tools to remove mating parts.
7) When it is hard to dissemble at room temperature, apply local heat until reaching 250°C and disassemble while hot. Then, remove any residual cured adhesive mechanically and clean parts with a proper solvent, acetone.
TECHNICAL INFORMATION:
Average handling time: 10 minutes (Conditions: 22°C)
Colour: Red
Corrosive: Non-corrosive
Flash Point: >93°C
Gap Filling: Up to 0.15 mm
Shelf Life : 36 Months
Specific Gravity: 1.035 (22°C)
Temperature range: -50°C / +200°C
Viscosity: 2000 - 5000 cPs (@2.5 rpm) 22°C,
STORAGE AND SHELF LIFE:
Keep product in its original container at 22°C and avoid to contact with direct sunlight. Storage below 5°C and above 30°C can negatively affect product properties.
Shelf life: 36 months.
PACKAGING:
50 ml x 120 pcs / box
250 ml x 36 pcs / box